60KVA CUMMINS SPECIFICATIONS
_{[ Home ] [ Up ] [ GSE Parts Department ] [ Feedback ] [ HOBART GROUND POWER ] [ Hobart Ground Power 400Hz & DC Data Sheets ] [ 400Hz POWER & DISTRIBUTION ] [ 400 Hz & DC LOAD BANKS ] [ HOBART PARTS QUOTE ] [ COLEMAN ENGINEERING ] [ HOBART GPU QUOTE ] [ Trilectron Ground Equipment ] [ Hangar 400Hz & DC Power Systems ] [ Aircraft Air Conditioners ] [ Hobart GPU Manuals ] [ Military Products Division ]}

HOBART DATA SHEETS

GET A QUOTE

Terms & Conditions of sale

Hobart Cummins Engine Driven Ground Power Unit                                                                                                                                                        

Specifications:

• Engine

·          Cummins B3.9 diesel operating at 2400 RPM

·          Operates at 110 Horsepower

·          Turbocharged 4-stroke 4 cylinder Diesel with inline Fuel Pump

·          Full application approval by Cummins Engine Co., Inc.

·          12 VDC battery system

·          Low oil pressure shutdown

·          Intake air restriction indication

·          Stop Lever governing for precise control and longer life

·          Electronic governor system

• Environmental

·          Operation Temperature:

-25^o F to +125^o F

-31^o C to + 52^o C

·          Relative humidity 0-100% noncondensing

·         No altitude derating required up to 10,000 feet, when running in normal operating range

• Overload

·          125% rated load for 5 minutes, 150% for 10 seconds

·          Individual outputs: 217 amps, 5 minutes

• Voltage

·          Transient voltage recovery time: to within 6 1% in 100 milliseconds (no load to rated load)

·          Within 620% deviation upon application/removal of 100% load rating

·          Modulation: does not exceed 0.5% of steady state voltage

·          Phase voltage displacement with balanced load: 12061.5

·          Phase voltage balance (with unbalanced load) does not exceed 4% with 1/3 rated current on any single phase with other two phases disconnected

·          Crest factor: 1.40460.07

·          Individual Harmonic Distortion: < 2%

·          Total Harmonic Distortion: <3% of the fundamental (RMS) voltage

• Regulation

·          Voltage Regulation: 61% no load to full load

·          Voltage adjust: 615 volts

·          IHD (individual harmonic content): <2%

·          Three phase average sensing, built-in Automatic line drop compensation, up to 5%

• Frequency

·          Regulation: 62Hz steady rate

·          Transient recovery: to within 65Hz in <2 seconds per ARP 5015

·          Modulation: <0.25% (1Hz)

• Protection

·          Meets MIL-STD-704E

·          Over voltage: instantaneous disconnect of load at 180 volts L-N, with inverse time delay down to 125 volts in 2 seconds

·          Under voltage: disconnects output below 100 volts L-N in 7 seconds

·          Over frequency: disconnects output above 420Hz in 5 seconds

·          Under frequency: disconnects output below 370Hz in 7 seconds

• Performance

·          Rating:  60 kVA, 3 phase, 4 wire, 115/200 volt Wye continuous

·          Meets or exceeds MIL-STD-704E Electrical Power Quality Requirements

• Finish

·          Anti-corrosive Polyester powder provides excellent weather resistance, flexibility and adhesion, plus a strong resistance to chemical agents such as glycol and skydrol

·          Standard colors are high gloss white over black frame and chassis

·          Custom colors require a paint chip or swatch for accurate color match

•  Displays / Instrumentation

• Engine

·          Meters: coolant temperature, ammeter, hour meter, oil pressure, fuel level

·          Indicator Lights: engine circuit on, air cleaner restriction, high coolant temperature, low oil pressure, engine stop delay action, low fuel

·          Switches: Engine start, engine stop, panel lights

·          Delayed shutdown for turbocharger protection

• Generator

·          Meters: frequency, ammeter, voltmeter

·          Indicator Lights: contactors on, overfrequency, underfrequency, overload, overvoltage, undervoltage

·          Switches: meter select, output contactors control, test / reset

•  Trailer

·          Tire Size:  5: 30 x 12 (21” diameter)

·          Ground clearance:  14”

·          Brakes:  Hand/lever actuated

•  Available Options:

·          Block heater kit, 120 V or 240 V

·          Transformer-Rectifier pack for 28.5 VDC

·          Automatic tow bar height stop

·          Spot light

·          Alternative mounting configuration: Stationary/fixed

·          Special paint scheme

·          Indicator beacons (low fuel, operating)

·          Second output

·          Fork lift pockets

·          Automatic cold weather ether start kit

Specifications are subject to change without notice.

(516) 546-0003            (800) 758-0044

_{[ GSE Parts Department ] [ Feedback ] [ HOBART GROUND POWER ] [ Hobart Ground Power 400Hz & DC Data Sheets ] [ 400Hz POWER & DISTRIBUTION ] [ 400 Hz & DC LOAD BANKS ] [ HOBART PARTS QUOTE ] [ COLEMAN ENGINEERING ] [ HOBART GPU QUOTE ] [ Trilectron Ground Equipment ] [ Hangar 400Hz & DC Power Systems ] [ Aircraft Air Conditioners ] [ Hobart GPU Manuals ] [ Military Products Division ]}

Send mail to WEBMASTER@AVIATIONGROUNDEQUIP.COM with questions or comments about this web site.
Copyright © 1999 Aviation Ground Equipment Corp.                                   
Last modified: January 24, 2008